Make sure to send us your feedback to review and wall to earn these point to use for next purchase. This feedback will enable us to improve our service to other customer in future. Thank you for purchasing at our store !
KLDSLR Retail Store
We will open every day at 10AM to 7PM daily.
Address : KLDSLR Lot 61-4A, Jalan SS2/75, 47300 Petaling Jaya
Online Orders
Regular checkout will be only process on Monday to Friday. Cut off time at 12PM for same day delivery. Special urgent case can be handle manually if you need. Please contact WhatsApp for assistance.
Shipping
All order that purchase before Cut Off time, will be send same day with Pos laju or Citylink. For KL Area, you may opt for High speed delivery to receive your item the same day evening.
Store Pickup
Store Pickup orders placed up to 12PM will be available for same-day pickup after 1PM until store closing time (Only for local Malaysia credit card / bank transfer transaction) . Foreign transaction will need 48 hours for fraud scanning. Store Pickup orders placed less than 1 hour from store closing, or while the store is closed, will be ready for pickup 30 minutes after the store reopens. For item that Pre-Order Status, or out of stock, pick up will be only available after item arrive. Our staff will contact you for the pick up when its ready.
The Blackmagic Design Studio Converter 2 inputs video signals transmitted over optical fiber and converts the signals to SDI for use with video switchers. When used in conjunction with the Blackmagic Design ATEM Camera Converter, you can send video signals up to 28 miles between camera and switcher using available optical fiber cables. By comparison, sending an HD-SDI signal over traditional copper cable is usually limited to about 300 feet, depending on the quality of the cable.
A typical set up using the Studio Converter 2 is to connect it between the switcher and up to four ATEM Camera Converter units. This setup allows the Converter 2 to receive the signals from the fiber cable, convert the signals to SDI using 10-bit processing, and send the signals to the switcher. The Converter 2 supports SD/HD signals, and when using the available ATEM Camera Converter you can use any camera with an SDI/HDMI output.
The Converter 2 can also be used as 4 independent simultaneous bidirectional SD/HD-SDI to optical converters. The Converter 2 features a built-in mic input, speaker and headphone jack that provides talkback audio for communicating with camera operators. The Converter 2 passes tally signals embedded in the SDI program stream. You can cascade multiple ATEM Studio Converter 2 units together when using more than 4 cameras. The Studio Converter 2 features a 1 RU design with built in rackmount ears for easy integration into existing studio configurations or production cases.